Assist" Menu - Grundfos MAGNA3 D Instrucciones De Instalación Y Operación

9.7 "Assist" menu

Navigation
"Home" > "Assist"
Press and go to the "Assist" menu with
The menu guides you through and offers the following:
• Assisted pump setup
• Setting of date and time
• Multipump setup
• Setup, analog input
• Description of control mode
• Assisted fault advice.
The "Assist" menu guides the user through the setting of the
pump. In each submenu, there is a guide that guides the user
through the setting of the pump.
9.7.1 "Assisted pump setup"
Navigation
"Home" > "Assist" > "Assisted pump setup"
This menu guides you through a complete pump setup, starting
with a presentation of the control modes and ending with the
setpoint setting.
9.7.2 "Setting of date and time"
Navigation
"Home" > "Assist" > "Setting of date and time"
This menu guides you through the setup of time and date. See
also section "Set date and time", page 52.
9.7.3 "Multipump setup"
Navigation
"Home" > "Assist" > "Multipump setup"
This menu offers the following options:
• Alternating operation
• Back-up operation
• Cascade operation
• No multipump function.
Setting: "Alternating operation", "Back-up operation" and
"Cascade operation"
1. Select the desired operating mode with
[OK].
2. Follow the step-by-step guide to complete the multipump
setup.
3. Check the entered values.
.
4. Press [OK] to confirm and enable the settings.
You can set a multipump system from a selected pump, which will
then be the master pump. Check the display to identify the master
pump in a multipump system. See fig. 62 and section Display
icons, page 43.
Fig. 62 Identify the master pump in a multipump system
A twin-head pump is set to multipump function from factory. Here
pump head I is defined as master pump. Check the nameplate to
identify the master pump. See fig. 63.
Fig. 63 Identify the master pump on a twin-head pump
For detailed information on the control modes, see section
8.5 Multipump modes.
Setting: "No multipump function"
1. Select the "No multipump function" with
[OK].
2. The pumps run as single-head pumps.
XXXXXXXXXXXXXXXXXXXXXXXX
P/N: XXXXXXXX
S/N: XXXXXXXX
PC: XXXX
Model: X
Assembled In USA
I is defined as master
or and press
I [A] P [W]
1 1
XXXX
XXXX
or and press
55