Safety Information; Electrical Connection; Safe Operation; Intended Use - Oase AquaAir Eco 250 Puesta En Marcha

Safety information

Electrical connection

• Special regulations apply to electrical installation in outdoor areas. Only allow a qualified elec-
trician to perform the electrical installation.
– The qualified electrician has the required professional training, knowledge and skills to per-
form electrical installations in outdoor areas. The qualified electrician can detect potential
risks and adheres to regional and national standards, regulations and directives.
– For your own safety, please consult a qualified electrician.
• Only connect the unit if the electrical data of the unit and the power supply match.
• Only plug the unit into a correctly installed outlet. Ensure that the unit is fused for a rated
fault current of max. 30 mA by means of a fault current protection device.
• Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use
(splash-proof).
• Protect open plugs and sockets from moisture.

Safe operation

• Do not use the unit, if electrical lines or the housing are damaged.
• A damaged connection cable cannot be replaced. Dispose of the unit.
• Do not carry or pull the unit by its power cable.
• Never make technical modifications to the unit.
• Only carry out work on the unit that is described in this manual.
• Only use original spare parts and accessories.
• Route lines so that they are protected from damage and nobody can trip over them.
• Should problems occur, please contact the authorized customer service or OASE.

Intended use

Only use the product described in this manual as follows:
• For aerating bodies of water.
• In compliance with the technical specifications.
The following restrictions apply to the unit:
• Do not use in accessible water basins.
• Never use the unit with fluids other than water.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
• Never run the unit without water.
• Do not use for commercial or industrial purposes.
EN
13