Tabla de contenido
Idiomas disponibles
Idiomas disponibles
26.
Do not move the base station (9) when the water boiler (1) and tea pot (13) are
on it.
27.
Do not fill above the max marking, hot water may spurt out.
28.
Ensure that the appliance is cool before cleaning. Remove the plug from the
mains after use and before cleaning.
WARNING - to avoid injuries
29.
Do not allow the mains lead to hang over corners (trip-wire effect).
ATTENTION - to avoid damage to the appliance or other property
30.
Place the appliance on a stable, flat surface which is not easily inflammable.
31.
The cable should not come into contact with the appliance when it is hot.
32.
The plug must be easily accessible so that you can pull it out quickly if
necessary.
33.
Never place the appliance near a gas flame, electric hotplate or other source of
heat. External heat can damage the appliance.
34.
Do not put the water boiler (1) or the tea pot (13) in the microwave because
they contain metal parts.
35.
If the tea pot (13) is not on the keep warm plate (12) or is empty, switch off the
keep warm plate (12) with the on/off button (22).
36.
The water boiler (1) may be used only with the electric base station (9) which
belongs to it.
37.
Do not put aluminium between the keep warm plate (12) and the tea pot (13).
This may damage the keep warm plate (12).
PLEASE NOTE: No liability can be accepted for any damage caused by misuse.
5
Prior to initial use
Make sure that any packing material has been removed from outside and inside of
the item.
Check that all parts are there (see chapter 3 "Description and scope of delivery").
Leave the specification plate and any warning notices on the appliance.
ATTENTION: Check the appliance for any damages. If there is any damage, do
not operate it and contact qualified service personnel.
Place the base station (9) on a heat/water resistant and flat even surface
Before initial use fill the water boiler (1) with water up to the MAX mark, heat the
water until it has boiled, empty and repeat this procedure. Clean the glass pot (13),
the push rod (17) and the tea strainer (14) with regular washing-up liquid in order to
remove any residue from the manufacturing process.
BEEM – Elements of Lifestyle
All manuals and user guides at all-guides.com
Seite/Page/Page/Página
18 / 49
Tabla de contenido
