Schwinn Discover HYBRID Manual Del Proprietário página 28

3 Assembly
Micro Adjust Seat with Pillar Seat Post
❶ Place the bottom plate on the pillar seat post. Be sure the
holes in the bottom plate and the holes in the seat post are
aligned. Figure 3.18
❷ Place the washer on the hex bolt and insert the bolt through
the bottom hole of the pillar seat post and bottom plate.
❸ Place the rails of seat into the grooves of the bottom plate.
❹ Place the top plate over the top of the seat rails. The hex
bolt should be inserted through the hole in the top plate.
❺ Insert the square nut onto the hex bolt and tighten
completely.
❻ Insert the pillar seat post into the seat tube and adjust the
seat height up or down until the rider feels they have
control of the bicycle and is comfortable.
Important! Be sure the minimum insertion marks do not go
past the top of the seat clamp and are not visible.
See Section 1, Fig. 1.2: Seat Height and Handlebar Reach.
❼ Lock the seat in place. Note: Refer to the section that
pertains to your seat clamping device (bolted or quick-
release) on the previous page for instructions.
❽ Check the seat to be sure it does not move.
26
5
Square nut
4
Top plate
1
Bottom plate
Pillar seat
post
2
3
Seat rails
6
7
Quick-release
seat clamp
6
Bolted seat
clamp
Figure 3.18