Setup And Connections - Palmer PLB2X8 Manual De Usuario

INSTALLATION & OPERATING:

SETUp AND cONNEcTIONS

Position the PLB2X8 in a dry place so that the natural air circulation is
not restricted. The amplifier power is converted into heat. It is impera-
tive to avoid accumulation of heat; otherwise, the PLB2X8 could become
damaged. Never cover up the ventilation slits on the base and cover.
Moreover, the box should not be placed in the direct proximity of devices
which also generate heat.
For wiring, please use only speaker cable with a corresponding cross-
section. As a rule, a cross-section of 0.75mm² is sufficient for short
cables of up to 2m in length. Longer cables should have a cross-section
of 1mm² or 1.5mm². This applies for amplifier outputs of up to approx.
150W.
The wiring really requires no further explanation; the amplifier is con-
nected to the PLB2X8 instead of the speaker cabinet. The input jacks
(INPUT 1 and INPUT2) are on the rear panel. In (dual) stereo mode, both
jacks are used. In mono mode, you must use only INPUT 1.
5