Electrolux 51AADK Instrucciones página 3

Instructions for conversion to 8 mbar town gas
for model 51AADK, 51ABDK, 51ACDK, HFG236, HFG458, HFG472
If you want to operate your hob using 8 mbar town gas, it must be conver-
ted (adapted).
1
Important: The conversion may only be performed by an authorised gas fitter.
1
Important: Before using for the first time check for leaks.
The conversion set consists of
Name of item
Main jet for high capacity burner
Main jet for normal capcity bur-
ner
Main jet for low capacity burner
Air regulator for high capacity
burner
Air regulator for normal capacity
burner
Air regulator for low capacity
burner
Auxiliary tool for air controller
Conversion label
Performing the conversion
1. Take off pan bracket, burner cover and burner crown without using tools
(fig. 1, 2).
2. Replace all main jets (fig. 3). To do this you will need a 7 mm socket spanner.
3. Screw the air regulators onto the main jets as tight as they will go
(fig. 4).
4. Remove all knobs and rubber seals on the control panel (fig. 5).
5. Adjust all low setting jet (fig. 5).
6. Use a water proof pen to write on the conversion label and stick it on the
underside of the hob near the gas tap (fig. 6).
7. As a final check, turn the knob of each burner quickly (in about 1 second)
from the maximum setting to the minimum setting. When you do this, the
flame must not go out. If this should happen, an adjustment of the low
setting jet is required.
8. After the conversion has been carried out all jets are to be re-sealed.
Label Number
4 burner
hob
282 1
210 2
142 1
16 mm 1
10 mm 2
10 mm 1
-
-
Number
2 burner
hob
1
1
-
1
1
-
1 1
1 1
3