Specifications; Preinstallation; Preparing To Install The Toilet; Removing An Existing Toilet - Dometic GROUP M65-700 Instrucciones De Funcionamiento

Specifications

4 Specifications
This section provides general specifications for the toilet.
Weight M65-700
Weight M65-5000
Fresh Water Supply Pressure
Water Inlet Size
Vent Fitting
Pumpout Fitting
Holding Tank Capacity
Minimum Water Consumption
per Flush
Average Water Consumption
per Flush

5 Preinstallation

This section describes the steps to complete prior to
installing the toilet.

5 .1 Preparing to Install the Toilet

1. Select a position in the bathroom where the toilet can
operate properly. Allow room for flushing the pedal
and clearance for raising the seat and lid. See "Toilet
Dimensions" on page 5.
2. Turn off the water supply to the toilet's location.

5 .2 Removing an Existing Toilet

I If there is no existing toilet, skip to "Installation" on
page 6.
1. Flush the toilet to drain the water from the bowl.
Have a towel or shallow container ready to
I
collect any residual water.
2. Disconnect and drain the water supply line.
3. Remove the fasteners anchoring the toilet to the floor.
4. Remove the toilet from the floor.
5. Dispose of the toilet, fasteners, and any removal
debris.
6
46 lbs (20.9 kg)
49 lbs (22.2 kg)
35–40 psi
0.5 in. (13 mm) NPT
5/8 in. (16 mm) O.D.
1.5 in. (38 mm) O.D.
6.5 gal (24.6 L)
0.1 gal (0.5 L)
0.3 gal (1.0 L)

6 Installation

This section describes how to install the toilet.

6 .1 Installing the Holding Tank

q
w
5 Positioning the Holding Tank
Holding Tank
q
Tank Mounting
w
Screws and Washers
1. Position the rear of the holding tank 0.8 in. (19 mm)
from the wall.
2. Mark the position of the mounting holes on the floor,
then remove the holding tank.
3. Drill a pilot hole for each mounting hole.
4. Move the holding tank back into position.
5. Secure the holding tank to the floor with the tank
mounting screws and washers.
I Do not over-tighten the screws.

6 .2 Installing the Thru-hull Fitting

1. Install the thru-hull fitting according to the
manufacturer's instructions.
The thru-hull fitting should be located well
I
above the water line and directly over the toilet.
Gravity-discharge Toilet
r
t
e
Tank Mounting Holes
e
Pumpout Fitting
r
Vent Fitting
t
EN