Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2610067141 GLM-BAT 09-21.qxp_GLM-BAT 9/27/21 2:36 PM Page 7
cable listed in the manual Specification
section to charge the Bosch battery
pack. Using other power adapter and
USB C cable may increase the risk of
fire, personal injury and property
damage.
in application higher than 5V 1A. Using
USB cable beyond its rating may
increase the risk of fire, personal injury
and property damage.
port is wet. Allow the USB C port to
dry out prior to charging battery.
Moisture on USB port during charge may
cause fire, serious personal injury
and/or property damage.
Note: The battery pack is supplied
partially charged. To ensure full capacity
of the battery pack, completely charge
the battery pack before using for the
first time.
Note: The battery pack can be charged
in or out of tool. Tool can be used while
charging.
The lithium-ion battery pack can be
charged at any time without reducing its
ion battery packs only with tools listed
in the Specification section of this
manual. Use of the battery pack with
other tools may increase the risk of fire,
personal injury and property damage.
not using it for extended periods.
When storing for extended periods, the
batteries can corrode and self-
discharge.
The lithium-ion battery is protected
against deep discharge by the Electronic
Charging Instructions
Use
only
power
adapter and USB C
Do
not
use
the
provided USB C cable
Do
not
charge
battery when USB C
Using Battery in Tool
Use
the
Bosch
rechargeable lithium-
Remove the batteries
from the tool when
service life. Interrupting the charging
procedure does not damage the battery
pack.
To charge the battery:
Insert USB plug in a USB compliant
device. Lift the USB C cover. Insert the
USB C plug into USB C port. Once
charging is complete, remove the USB C
plug and close the USB C cover to
protect your battery.
Battery LED Indicator
The LED light is located under USB-C
port cover. The battery LED indicator
shows the charging state of the battery
pack.
LED
Status
Off
Charger not connected
On
Full charge
Red
Charger input is wrong
Yellow
Charging
USB C cover is completely closed.
Moisture entering battery may cause
fire, serious personal injury and/or
property damage.
Cell Protection (ECP). A protective
circuit switches the laser level off when
the battery is drained.
• Following the automatic shut off of
the tool, do not continue to press the
On/Off button. The battery can be
damaged.
To insert the charged battery pack, slide
it into the battery port until you feel it
lock into position. Do not use force.
To remove the battery pack, press the
Li-ion battery pack locking mechanism
and pull the battery pack out of the
battery port. Do not use force.
7
After
charging
battery, ensure the
Tabla de contenido
