Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Input, output and audio controls
Input of the signal to be amplified. Connect to the radio/player
1. INPUT:
through high quality shielded RCA cables to prevent unwanted noise.
Signal level control in the amplifier input.
2. LEVEL:
3. CROSSOVER:
▪
HIGH PASS FILTER (H.P.F.):
frequency from 10Hz to 90Hz that will be reproduced by the amplifier.
▪
LOW PASS FILTER (L.P.F.):
frequency from 90Hz to 15KHz that will be reproduced by amplifier.
4. BASS BOOST:
▪
Variable control for bass boost from 0dB to +10dB.
BASS:
▪
Variable control for BASS boost action from 30Hz to 70Hz.
FREQ:
4.1. MID BASS BOOST:
at 270Hz.
4.2 MID HIGH BOOST:
boosting midrange at 2KHz frequency.
It provides cooling of the amplifier. Install in a cool place without
5. COOLER:
obstruction of air inlets and outlets.
This switch allows you to turn the FLAT mode on or off. Settings made
6. FLAT KEY:
on the CROSSOVER and BOOST controls will be turned off when using this mode.
1
2
3
This variable control allows you to select the initial
This variable control allows you to select the final
Variable control from 0dB to +10dB with bass boost
Variable control from 0dB to +10dB with acting on
12
4
4.1 4.2
5
6
Tabla de contenido
