Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Indicator lamps
Lighted
Off
NOTE:
•
Depending on the conditions of use and the
ambient temperature, the indication may differ
slightly from the actual capacity.
Switch action
1
► 1. Switch trigger
CAUTION:
•
Before installing the battery cartridge into the
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
To start the tool, simply pull the switch trigger. The tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
NOTE:
•
The tool will stop three minutes after pulling the
switch trigger.
Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after switch trigger
release, have tool serviced at a Makita service center.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Lighting up the front lamp
CAUTION:
•
Do not look in the lamp or see the source of
lamp directly.
1
► 1. Lamp
► 1. LED display 2. Lamp button
Every time the lamp button
pressed, the lamp status is alternatively changed from
the ON to the OFF and from the OFF to the ON.
With the lamp button in the ON status, pull the switch
trigger to turn on the lamp. To turn off, release it and
the lamp goes out approximately 10 seconds after
releasing.
With the lamp button in the OFF status, even if the
trigger is pulled, the lamp will not light on.
NOTE:
•
To make sure the status of lamp, pull the trigger.
When the lamp lights up by pulling the switch
trigger, the lamp switch is in the ON status.
When the lamp does not come on, the lamp
switch is in the OFF status.
•
During the operation of switch trigger, the lamp
status cannot be changed.
•
For approximately 10 seconds after releas-
ing the switch trigger, the lamp status can be
switched.
6 ENGLISH
1
2
on the LED display is
Tabla de contenido
