Worx Professional Sonicrafter WU670 Traducción De Las Instrucciones Originales página 11

4
MOUNTING THe sUCTION deVICe(see Fig. C, d)
When vacuuming, mount the suction device as shown in C1-D2.
(WU670.1)
Note: Using the sanding pad perforated. You can only do the
vacuuming after fitting the dust collector.
5
OPeRATING THe ON/OFF sWITCH
To start the machine, push the On/Off switch (13) forward so that the
"I" is indicated on the switch.
To switch off the machine, push the On/Off switch (13) toward the
rear so that the "0" is indicated on the switch.
6
UsING THe VARIABLe sPeed CONTROL
Select oscillation frequency (speed) while the motor is running.
The variable speed control (14) can be used to set the optimum
oscillating frequency according to the accessories used and the
respective application.
High oscillation frequency:
Sanding, sawing, rasping and polishing stone and metal.
Low oscillation frequency:
Polishing varnishes.
7
sANdING
Typical application: Wood, metal; small areas, especially corners,
edges and places difficult to access.
Select high oscillation frequency.
Sand with a constant movement and light pressure.
Heavy pressure does not increase the removal – the sanding sheet
merely wears faster.
All manuals and user guides at all-guides.com
8
9
10
9
sAWING WITH THe seMICIRCLe sAW BLAde
The workpiece must be inserted firmly or clamped tightly before it is
cut.
Typical application: wood, PVC, soft metal sheet.
Select high oscillation frequency .
The saw blade lasts longer if the wear is distributed evenly. To ensure
an even distribution, loosen the saw blade, rotate it and retighten
firmly.
sAWING WITH THe UNIVeRsAL eNd CUT sAW BLAde (see
Fig. e)
Warning: The sawing teeth are very sharp. do not touch
during mounting and application.
The workpiece must be inserted firmly or clamped tightly before it is
cut.
Typical application: wood, metal (e. g. nails),plaster board and soft
plastics.
When plunging and sawing use a slight pendulum motion, to allow
sufficient chip removal.
sCRAPING
Typical application: Scraping off old varnish or adhesives, removing
glued carpeting, e. g. on stairs or other small to medium-sized
surfaces.
Select medium / high oscillation frequency.