General Safety Instructions - Speedaire 440G06A Manual De Instrucciones Operativas

GENERAL SAFETY INSTRUCTIONS

Read the following precautions and instructions before you begin assembly or use.
Failure to comply with these instructions could result in personal injury or property damage.
DANGER
INSTALLATION
TENSION ADJUSTMENT
2
Note that the reel is rewound by a high tensioned spring.
Do not disassemble the ratchet device when the reel is rewound by
high tension.
DO NOT allow cable to retract in an uncontrolled manner.
Always guide cable back to reel. Failure to do so can result in
damage to reel or personal injury.
Be sure reel base is securely grounded to mounting surface.
Check for continuity following installation.
On painted surfaces, remove paint at bolt location, use external tooth
lockwashers or run ground wire from reel base to grounded object.
Failure to ground will prevent reel from performing its intended function
and could result in personal injury.
Mount reel to grounded, metal surface using four holes in mounting base.
To minimize wear on cable and cable guide, reel should be mounted in direct
line with work so that cable is pulled out as straight as possible during use.
Never add / remove tension when the cable is extended from the reel.
The cable must always be fully wound on the reel.
1. Hold shaft securely with wrench and remove 2 screws from hub.
2. Turn shaft clockwise / counter-clockwise to add / remove tension
(one full turn at a time).
3. When desired tension is achieved, replace the 2 screws.
Failure to follow all general safety information can result in a fatality,
personal injury and/or property damage!