Care And Cleaning; Technical Data - Electrolux ERT17004W8 Manual De Referencia Rápida

10 electrolux
Important! If the ambient temperature is high or
the appliance is fully loaded, and the appliance is
set to the lowest temperatures, it may run
continuously causing frost to form on the rear

CARE AND CLEANING

Caution! Unplug the appliance before
carrying out any maintenance operation.
This appliance contains hydrocarbons in its
cooling unit; maintenance and recharging
must therefore only be carried out by authorized
technicians.
Many proprietary kitchen surface cleaners con-
tain chemicals that can attack/damage the plas-
tics used in this appliance. For this reason it is rec-
ommended that the outer casing of this appli-
ance is only cleaned with warm water with a little
washing-up liquid added.
After cleaning, reconnect the equipment to the
mains supply.
Defrosting of the refrigerator
Frost is automatically eliminated from the evapo-
rator of the refrigerator compartment every time
the motor compressor stops, during normal use.
The defrost water drains out through a trough in-
to a special container at the back of the appli-
ance, over the motor compressor, where it evap-
orates.
It is important to periodically clean the defrost wa-
ter drain hole in the middle of the refrigerator com-
WHAT TO DO IF...
Normal Operating Sounds
• You may hear a faint gurgling and a bubbling
sound when the refrigerant is pumped through
the coils or tubing. This is correct.
• When the compressor is on, the refrigerant is
being pumped around and you will hear a whir-
ring sound and a pulsating noise from the com-
pressor. This is correct.

TECHNICAL DATA

Dimension
The technical information are situated in the rat-
ing plate on the internal left side of the appliance
and in the energy label.
wall. In this case the dial must be set to a higher
temperature to allow automatic defrosting and
therefore reduced energy consumption.
partment channel to prevent the water overflow-
ing and dripping onto the food inside. Use the spe-
cial cleaner provided, which you will find already
inserted into the drain hole.
• The thermic dilatation might cause a sudden
cracking noise. It is natural, not dangerous phys-
ical phenomenon. This is correct.
• When the compressor switches on or switches
off, you will hear a faint "click" of the tempera-
ture regulator. This is correct.
Height
Width
Depth
850 mm
595 mm
635 mm