Tabla de contenido
Idiomas disponibles
Idiomas disponibles
KING AL
OPERATION
Locating Wire Path
Walk around the transmitter location while pointing the probe toward
the ground. When you are directly above the wire path, the unit will
go silent—no tone will be detected. As the receiver is moved to either
side of the wire path the intensity of the tone signal will increase. To
determine the wire path, follow the null. (Refer to Figure 2).
FIGURE 2: Locating Wire Path
Finding Wire Breaks and Nicks
In order to use the King AL unit to locate a fault, lower the receiver
sensitivity when pointing to either side of the null. The change in
signal intensity will become apparent. Do not allow the meter to
read above 10.
NOTE: Most direct bury wire will have a path to ground due to
insulation imperfections, nicks and bad slices. If a path to ground
does not exist, create one by grounding the remote end. In order
to be located the wire must have a path to ground.
I
KING INNOVATION
7
Capítulos
Tabla de contenido
