Wall Mounting - Speedaire 437J35A Manual De Instrucciones Operativas

ASSEMBLY INSTALLATIONS
1 Unpack and inspect reel for any damage. Turn the reel by hand to check whether the reel is
operating smoothly or not.
2 The swing bracket was packed separated with the reel in the box.
3 There are twelve holes in each base of the swing bracket and reel.
4 Disassemble the bolts and nuts fastened to the swing bracket base.
5 Align the holes in the base of the reel and swing bracket, and fasten the bolts
and nuts that were disassembled in step 4 to the four holes in the corner.
6 After installing the swivel mounting bracket with anchor brackets
(if welding is required, it should be welded), then install the reel by placing the pin between
the reel and swivel mounting bracket.
7 Reel are supplied with plastic crank handle to prevent damage on the move, the handle is
packaged folded. When using the handle, please unfold it.
8 Apply thread sealant to inlet hose and connect to the swivel joint on reel
Typical mounting position
Figure 2
Lock Function
Figure 3
4

Wall Mounting

If the hose is taken out when the reel is not mounted correctly, the reel
can fall down and become damaged. The user can also be injured.
Figure 4
When the reel is mounted to the wall it should
be mounted correctly.
When the user opens the box, the lock on the
swing bracket is unlocked.
In order to use the reel to one direction, the lock
must be locked.
Turn the reel in the desired direction and align
the holes of base of the reel and the the bracket.
Pull the knob downward, turn it 90 degrees
counterclockwise, put the knob in the hole of
desired direction inserting the end of knob into
the groove.