Troubleshooting; Battery Charger; Lawn Mower - Husqvarna LC 247i Manual De Usuario

7. Make sure that the blade is aligned with the center of
the motor shaft.
8. Lock the blade with a block of wood. Attach the
spring washer and tighten the bolt and washer with a
torque of 23–28 Nm. (Fig. 49)
9. Pull the blade around by hand and make sure that it
turns freely.
Battery
LED on the battery
The green LED flashes.
The error LED flashes.
The error LED is on.

Battery charger

LED on the battery
charger
The error LED flash-
es.
The error LED is on.

Lawn mower

The warning indicator (error LED) is found below the
battery lid ((LC 247i)) or on the control panel
((LC 347iVX, LC 353iVX)).
1696 - 002 - 03.12.2021

Troubleshooting

Cause
The battery voltage is low.
The battery is weak.
The temperature in the work environ-
ment is too high or too low.
Overvoltage.
The cell difference too much (1V).
Cause
The temperature in the work en-
vironment is too high or too low.
WARNING:
The blade is very sharp and cuts can
easily occur.
10. Start the product to do a test of the blade. If the
blade is not correctly attached, there is vibration in
the product or the cutting result is unsatisfactory.
Solution
Charge the battery. Refer to
on page 15 .
Charge the battery. Refer to
on page 15 .
Use the battery in temperatures between 5 °C - 40
°C.
Make sure that the mains voltage is the same as
on the rating plate on the product.
Remove the battery from the battery charger. Wait
5 seconds and try again to charge the battery. If
the problem continues, speak to an approved
service agent.
Speak to an approved service agent.
Solution
Use the battery charger in temperatures between 5 °C -
40 °C.
Speak to an approved service agent.
Use heavy duty gloves.
To charge the battery
To charge the battery
19