To Get A Good Result; To Cut Grass Without A Grass Catcher Or Mulch Plug Attached; Maintenance; Maintenance Schedule - Husqvarna LC 247i Manual De Usuario

3. To remove the battery, push the 2 release buttons
and pull out the battery. (Fig. 42)
4. Charge the battery if it is weak. For more
information, refer to
15 .
To stop the product (LC 347iVX,
LC 353iVX)
WARNING:
before you let the product out of view.
1. Release the motor brake handle to stop the motor.
(Fig. 43)
2. Push the ON/OFF button on the control panel. All
LED lights and symbols on the display go out. (Fig.
44)
3. Open the battery lid and turn the safety key to 0.
(Fig. 45)
4. To remove the battery, push the 2 release buttons
and pull out the battery. (Fig. 46)
5. Charge the battery if it is weak. For more
information, refer to
15 .
Note:
The product is automatically de-energized if you
do not operate it for some minutes. To start the product
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Do a general inspection
Clean the product
Do a check of the start inhibitor *
Make sure that the safety devices on the product are not defective *
Examine the cutting equipment
Examine the cutting cover *
1696 - 002 - 03.12.2021
To charge the battery on page
Turn the safety key to 0
To charge the battery on page
Before you do
again, refer to
LC 353iVX) on page 16 .

To get a good result

• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
• Keep the cutting cover clean. Buildup from grass and
dirt on the inner side of the cutting cover can
decrease the cutting result. Refer to
product on page 18 .
To cut grass without a grass catcher or
mulch plug attached
• Lift up the rear cover and remove the grass catcher.
• If a mulch plug and a mulch blade are attached,
remove them.
• Close the rear cover before you operate the product.
When you operate the product, the cut grass discharges
below the rear cover.

Maintenance

For more detailed information, refer to
www.husqvarna.com.

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety on page 9 .
To start the product (LC 347iVX,
Each use Monthly
X
X
X
X
X
X
To clean the
Each
season
17