Tabla de contenido
Idiomas disponibles
Idiomas disponibles
STAMP AND CALIBRATE HOLES FOR FLOW-FORM RIVETS
If using Flow-Form rivets, it is necessary to pre-drill the metal before riveting. The stamping matrix T1 and T2 above
enables precise drilling and 6.5mm hole calibration for Flow-Form rivets.
After stamping, the punch is pushed into the metal to
be assembled. Then, it is necessary to swing the riveting
machine to release the punch and remove it from the
metal.
INSTALLATION OF FLOW FORM RIVETS
8
SELF PIERCING RIVETER 10T
NOM DU OU DES PRODUITS
RESULT OF THE INSTALLATION OF SELF-PIERCING RIVET
Before assembling metal sheets with Flow-Form rivets, it is necessary to pre-drill the metal (see
the procedure above). Installation of Flow-Form rivets use F1 and F2 matrices.
EN
FR
8
Tabla de contenido
