Makita DFL651F Manual De Instrucciones página 7

NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp. Be
careful not to scratch the lens of lamp, or it may lower
the illumination.
Function
Check of the LED When the battery cartridge is installed,
indicator, light and the tool checks for its LED indicator,
beeper operation light and beeper.
Detection of switch
When the battery cartridge is installed
trigger operation
with the switch trigger pulled, the tool
when installing
stops to avoid unintentional start.
battery
Auto-stop
The tool setting has been achieved
with fastening
and the tool has stopped.
completion
The tool has not completed the tool
setting because the switch trigger
Alarm against
has released before reaching the set
insufficient
values. Otherwise, the settings of
fastening
"Failure Criteria for Phase" has been
achieved.
Intermission The tool is in the intermitting period
between the configured by the setting of "Shift to the
phases next Phase".
When the operator starts to re-fasten
Double-hitting
an already-fastened screw, the tool
detection
detect it and stops.
Alarm for low The battery power became low and it is
battery capacity time to replace the battery cartridge.
Auto-stop with low
The battery power is almost used up
remaining battery
and the tool stopped.
capacity
The battery voltage dropped
Anti-reset of
abnormally for some reason, and the
controller
tool stopped.
Overheat Tool's controller heated up abnormally
protection and the tool stopped.
Motor failure Motor failure has been detected. At this
detection time, tool does not work.
Status of the tool
LED indicator / Beeper (Fig. 7)
LED indicator / Beeper on the tool shows the following
functions.
Status of the LED indicator/
beeper
LED indicator
Lights up first in
A series of
green, next red.
very short
(And then the light
beeps
comes on.)
Blinks in red
A series of
and green
short beeps
alternatively.
Lights up in green
for approximately
one second.
Lights up in red. A long beep
Lights up or
blinks in green
(depending on
settings)
Lights up in red. A long beep
Blinks in red A series of
slowly. long beeps
Lights up in red. A long beep
Blinks in red
A series of
and green
short beeps
alternatively.
Blinks in red A series of
quickly. short beeps
Blinks in red
A series of
and green
short beeps
alternatively.
Action to be
taken
Beeper
–
Release the
switch trigger.
– –
Retighten the
screw.
– –
–
Replace the
battery with fully
charged one.
Replace the
battery with fully
charged one.
Replace the
battery with fully
charged one.
Remove the
battery cartridge
immediately and
cool the tool
down.
Ask your local
Makita Service
Center for repair.
7