Key At - Welding Process; Key As - Working Mode; Key Ar - Command Program; Keyh - Synergy - Cebora 366 Manual De Instrucciones

CEBORA S.p.A.
7.1

Key AT - Welding process.

Operative in Parameter Selection Internal mode.
Each time the key is pressed selects a different welding process.
The process selected is indicated by the lighting of the corresponding led.
Led AX Tig-DC process.
Led AV Tig-AC process.
Led AW MMA process.
7.2

Key AS - Working mode.

Operative in Parameter Selection Internal mode.
The mode selection is indicate by the lighting of the corresponding led.
"Hot Start" function, active only in MMA.
Led D
"Arc Force" function, active only in MMA..
Led C
Led E Tig-CONTINUOUS welding, with arc ignition by high voltage/frequency.
Led B Tig-PULSED welding, with arc ignition by high voltage/frequency.
Led A Tig-CONTINUOUS welding, with arc ignition by contact (crawls) (not available).
Led AU Tig-PULSED welding, with arc ignition by contact (crawls) (not available).
7.3

Key AR - Command program.

GB
Selection blocked in "two-stage".
Led G Spot (not available, always off).
Led F Two-stage (always lit).
Led W Four-stage (not available, always off).
Led X Special program (not available, always off).
Led Z Welding with three levels of current and four-stage (not available, always off).
Led AA Welding with two levels of current and four-stage (not available, always off).
7.4 Key H - Synergy.
Operative in Parameter Selection Internal mode.
The short pressure (< 0,7 sec.) of this key enables the "synergy", where availlable, and allows the
selection of Material, Welding Position, Thickness and electrode Diameter.
The selection is carried out with knob Y and the parameter is visualized on display U.
If after to have selected the parameters the electrode diameter in not confirmed, pressing this key briefly
will exit synergy. If instead, after to have confirmed the electrode diameter, it is wanted to exit from
synergy it is necessary to press it for longer time (> 0,7 sec.).
7.4.1 Led I - Synergy.
It lit together to one of led L, M, S or R, in order to indicate the parameters that is possible to adjust.
7.4.2 Led L - Material.
The types of the selectable materials are in relation to the welding process, and are:
 In Tig-DC the stainless steel (SS), the Copper (Cu), the Iron (FE) and the Titanium (ti).
 In Tig-AC the aluminium (AL), magnesium (MG).
7.4.3 Led M - Welding position.
The abbreviation that appears on the display U
meets ISO6947 standards and corresponds to
the welding positions listed in the figure a side.
The ASME abbreviation are distinguished by a
number plus a letter.
7.4.4 Led S - Thickness.
The display O lights and shows the set current;
the display
corresponding to the current.
Turning the knob Y changes the thickness and the current will also be adjusted accordingly. Obviously
the thickness and corresponding current will be measured in relation to the material settings and of
welding position.
3300279-C
U shows the thickness
36
17-03-2016