Start Up; Operation - Kärcher IC 15/240 W Manual Del Usuario

Pull the waste container backwards out
of the device.
Connect the black earthing cable to the
battery and tighten the clamp screw.
Insert the waste container into the appli-
ance.
Open the waste container lid.
Tilt down the suction head.
Freewheel lever for moving the appli-
ance without adjusting self-drive (see
below).
The machine can be moved in 2 ways:
(1) By pushing it (see device without engag-
ing self-propulsion).
(2) By driving it (see device by engaging
self-propulsion).
Device without engaging self-pro-
pulsion
Danger
Risk of injury! Before engaging the free-
wheel operation, the machine must be se-
cured to prevent it rolling away.
Open the device hood and secure it us-
ing the hood support.
1 Freewheel lever
Press the red freewheel lever down-
wards, then move it to the left and lock
it in.
This blocks the travel drive function.
Close cover.
The machine can now be pushed.
Note
Do not move the machine for long distances
without engaging self-propulsion, a speed
of 6 km/h should not be exceeded.
Moving device by engaging self-
propulsion
Press the freewheel lever downwards,
then move it to the right and lock it in.
The travel drive is now ready for operation.
Close cover.
The appliance can now be driven.
Install attachment sets
Note
The attachment sets mentioned here are
not part of standard delivery of the device
and need to be ordered separately accord-
ing to requirements.
The attachment sets not listed here have
their own separate assembling instructions.
Attacchment set: Steering roller
The steering roller is attached to the front
end of the suction pipe.
All manuals and user guides at all-guides.com
Move the fastening clip of the steering
roller over the suction pipe.
Align steering roller and close quick-
snap.

Start up

General notes
Park the machine on an even surface.
Remove ignition key.
Refuelling
Danger
Risk of explosion!
– Only use the fuels specified in the Oper-
ations Manual.
– Do not refuel the machine in enclosed
spaces.
– Smoking and naked flames are strictly
prohibited.
– Ensure that no fuel reaches the hot
open surfaces.
– Use only those cans that have been ap-
proved for fuel.
Switch off engine.
Open the device hood and secure it us-
ing the hood support.
Open fuel filler cap.
Use "regular unleaded petrol".
Fill tank to max. 2.5 cm below the upper
edge of the filler nozzle.
Wipe off any spilt fuel and close fuel fill-
er cap.
Close cover.
Inspection and maintenance work
Check engine oil level. *
Check fill level of fuel tank.
Check hydraulics fluid fill level. *
Empty the waste container.
Check tyre pressure. *
* For description, see section on Care and
maintenance.
Insert the garbage sack (only with
the garbage sack accessory kit)
You need the garbage bag accessory kit if
the vacuumed material is to be collected in
a garbage bag.
Tilt the suction head upward.
1 Sleeve
2 Garbage bag, 240 litres
Place the cover down on the floor with
the holder loops.
Push the garbage sack over the cover.
Turn the cover along with the garbage
back and insert it into the garbage con-
tainer with the shorter side at the rear.
Place the upper edge of the garbage
sack around the edge of the garbage
container.
Tilt down the suction head.

Operation

Danger
Long hours of using the appliance can
cause circulation problems in the hands on
account of vibrations.
It is not possible to specify a generally valid
operation time, since this depends on sev-
eral factors:
– Proneness to blood circulation deficien-
cies (cold, numb fingers).
– Low ambient temperature. Wear warm
gloves to protect hands.
– A firm grip impedes blood circulation.
– Continuous operation is worse than an
operation interrupted by pauses.
In case of regular, long-term operation of
the device and in case of repeated occur-
15
English