Using The Quick Lock Lever; Operating Instructions For The Cut-Off Saw; Using The Cut-Off Saw - Kawasaki 691783 Manual De Instrucciones

USING THE QUICK LOCK LEVER

The work vise is equipped with a threaded screw clamp
and handle for tightening the vise. The clamp is also
equipped with a quick lock/release mechanism as stan-
dard equipment. The clamp can be tightened against
the workpiece in the vise by turning the handle clock-
wise and loosened by turning the handle counterclock-
wise. To use the quick lock/release mechanism, follow
the steps below. See Figure 5.
1. Release the tension on the screw clamp by turning
the handle counterclockwise for 1/2 to 1 full turn.
2. Lift the quick lock lever up and pull back the
screw clamp handle sliding the vise open.
3. To tighten, lift the quick lock lever
up and push the screw clamp for-
ward against the workpiece.
4. Push the quick lock lever down into
release mechanism.
5. Turn the screw clamp clockwise to
securely tighten the workpiece in the
vise.

OPERATING INSTRUCTIONS FOR THE CUT-OFF SAW

Do not use the Cut-off saw if the power cord (or exten-
sion cord, if used) is worn, cut, or damaged in any other way. A worn or dam-
aged power cord must be replaced immediately. Contact Alltrade Customer
Service to obtain the proper replacement power cord. Failure to adhere to
this warning could result in damage to the Cut-off saw motor, fire, or severe
electrical shock or even death to the operator.

USING THE CUT-OFF SAW

Disconnect the abrasive Cut-off saw from the AC power
source eliminating any accidental starting of the motor.
Before using the saw, ensure the wheel has cooled down from any previous
actions. Wear approved leather work gloves when handling the various
workpieces and to protect the hands from a hot Cut-off wheel.
All manuals and user guides at all-guides.com
WORKPIECE
QUICK LOCK/RELEASE
LEVER
FIGURE 5. USING THE
QUICK LOCK LEVER
19
FOLLOW THE INSTRUCTIONS BELOW TO OPERATE THE ABRASIVE CUT-OFF
SAW.
1. Adjust the angle of cut. See ADJUSTING THE WORK VISE on pages 17-18.
2. Place the workpiece inside the vise and turn the vise handle clockwise to
securely tighten the workpiece in the vise.
3. Plug the power cord into an approved GROUNDED AC receptacle.
4. Grip the handle and place thumb over the safety button.
TRIGGER SWITCH
SAFETY BUTTON
5. Press the safety button with thumb. Squeeze the trigger switch. Release the
safety button.
6. Allow the Cut-off saw to spin up to full speed.
7. Slowly pull down on the handle while continuing to squeeze trigger switch.
Lower the Cut-off wheel slowly into the workpiece.
8. Ensure the abrasive Cut-off wheel cuts completely through the workpiece.
Should the Cut-off wheel fail to pass through the workpiece, raise the handle
until it clears. Turn off the Cut-off saw and remove the power cord from the AC
receptacle. Refer to SETTING THE CUT-OFF WHEEL DEPTH GAUGE.
9. Once the cut is completed, turn off the Cut-off saw by releasing the trigger
switch. This also allows the safety button to return to the "OFF" position.
10.Unplug the Cut-off saw from the AC power source. Ensure the abrasive wheel
has stopped spinning before removing the workpiece.
FIGURE 6. OPERATING
THE CUT-OFF SAW
VISE
20