Stihl KM 130 R Manual De Instrucciones página 18

English
g if the engine is cold
e for warm start – also use this posi-
tion if the engine has been running
but is still cold.
Press the fuel pump bulb (9) at least
N
five times – even if the bulb is filled
with fuel.
Starting
Place the power tool on the ground
N
so that it rests on the machine
support: Check that the working tool
is not touching the ground or any
other obstacles – see also
"Starting / Stopping the Engine" in
the KombiTool instruction manual.
Make sure you have a safe and
N
secure footing.
Hold the unit with your left hand and
N
press it down firmly – your thumb
should be under the fan housing.
16
NOTICE
Do not stand or kneel on the drive tube.
Hold the starter grip with your right
N
hand.
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Crank the engine until it begins to
N
fire. After no more than five
attempts, turn the choke knob to e.
Continue cranking.
N
As soon as the engine runs
Blip the throttle trigger. The slide
N
control moves to the normal run
position F – and the engine settles
down to idle speed.
WARNING
Make sure the carburetor is correctly
adjusted. The working tool must not
rotate when the engine is idling.
Your machine is now ready for
operation.
Stopping the engine
Push the slide control in the
N
direction of the arrow on the stop
symbol (h) to STOP-0.
At very low outside temperatures:
As soon as the engine runs:
Blip the throttle trigger to disengage
N
the starting throttle position. The
slide control moves to the normal
run position (F) – and the engine
settles down to idle speed.
Open the throttle slightly.
N
Warm up the engine for a short
N
period.
If the engine does not start
Choke knob
If you did not turn the choke knob to e
quickly enough after the engine began to
fire, the combustion chamber is flooded.
KM 130 R