Idiomas disponibles
Idiomas disponibles
Before the installations of the mounting kit please guarantee that the manufacturer
guidelines for your vehicle are not impaired.
Country-specific rules must be taken into account.
The chassis of the most trailers and semi trailer truck is manufactured from ingot iron or
structural steel and the mounting kit can be welded without problems.
But there are also chassis, which are manufactured from tensile strength steel or aluminium
alloy. In this case only the possibility is to screw on the mounting kit.
Use thereby as many existing drillings as possible.
If new holes must be drilled, it is advisable to contact the vehicle manufacturer because the
guidelines of them should not be impaired.
With the Crayler on the tail of your vehicle the weight distribution is naturally changed.
In order to guarantee that this is in the context of the legal regulations of the respective user
country, it must be accomplished an axle load calculation.
The mounting kit QV07MS2A is able to adapt various types of equipments of the type CR
regarding the choice of the body builder (V1 = variant 1 or V2 = variant 2).
Please decide according the sheet DTQV07MS02/03 page 0200 (last sheet of the mounting
instruction), which equipment you'd like to choose.
With the choice of the body V1, you are able to adapt all of the listed equipment, except the
CR50- Palreach.
With the choice of the body V2, you are able to adapt all of the listed equipment, except the
CR65.
Example:
You've bought a CR50 with a tyre equipment 31x15.5-15
You've chosen the body variant V2. so you can adapt all CR-equipment, listed on the
sheet DTQV07MS02/03 page 0200, except the CR65.
First step of the body variant V2, the two side lashes (QV07M0401) has to be cut and
afterwards the mounting kit has to be build up regarding the instruction.
Adjusting of the device: (see table in the sheet DTQV07MS02/03 page 0200)
Push in the tyre block to position A and pin the block in hole 1.
The hanging position of the tension plate of the bolt of the device is the drilling
II.
The device should be possible to mount on the caring vehicle, like shown on the sheet
010.0500.
If you want to mount a CR 45 on this body with a tyre equipment 26x12-12, you just
have to push in the tyre block to position B and pin in hole 1
The hanging position of the tension plate for the bolt at the device is also the
drilling II
If you need any further information, please contact our dealer.
General references
