ANLAN SD-8810 Manual De Usuario página 11

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
If the power automatically turns off immediately after hearing
"bibibi" , which means the battery power is low. Please charge.
The indicator light flashes red when charging, and the indicator light
flashes blue when charging is completed.
The device may become hot during charging, but this is not fault.
Unplug the charging cable after charging to prevent overcharging. If
you continue to charge for a long time after the charge is completed,
it will consume the built-in battery and shorten the life.
The room temperature suitable for charging is 15 to 30℃. Charging at
low temperature may shorten the battery life, so charge the device at
an appropriate temperature. In addition, the charging speed may
decrease when below about 0℃.
To protect the built-in battery, charge it once a month even if it will
not be used for a long time.
If the battery is fully charged but the operating time is short, the
battery has reached the end of its life.
Before using
Skin Test
Please check the compatibility of the gel (or cosmetics) in combination
with this product to see if it is suitable for your skin.
※Be sure to test to prevent skin problems.
1.
Wash the part to be tested (inside the arm) with soap and wipe it off
with a towel.
2.
Apply gel (or cosmetics) (apply thinly)
3.
Turn on the power and apply it to the testing part
>17
①Turn on the power
②Press the head on the skin and move slowly in a circular motion
(about 10 seconds)
③Remove it from your skin and move it again for about 10 seconds.
(When finished, let the testing part air dry)
4.
Don' t rub the testing part for 24 hours.
When you have a skin problem with 24 hours.
Discontinue use with gels (or other cosmetics).
Operation
1.
Press and hold to turn on / off the power
The power will not turn on while charging.
2.
Short press to select the mode
RF mode: red light EMS mode: blue light
3.
Short press to select the level
3 level RF mode: 38-40-42℃
3 level EMS mode
※EMS mode does not change temperature
※Be sure to set it to "Level 1 (minimum)" when using it for the first time or you
get used to it.
bibi
Level 1
※During use, there is a beep timer sounds every 10 seconds.
bibibi
Level 2
Level 3
bi
18>
Tabla de contenido
loading

Productos relacionados para ANLAN SD-8810

Tabla de contenido