General Characteristics - Cembre ECW-H3D Manual De Uso Y Mantenimiento

1. GENERAL CHARACTERISTICS

– Application range: the head is suitable for compression of electrical connectors on conductors
An adapter AU230-130D is available as optional extra enabling the head to utilise the semi-circular
slotted dies which are common to most 130 kN tool. Also available is a series of dies for the compres-
sion of DIN electrical connectors, and a die for cutting copper, aluminium, aldrey, aluminium-steel
and steel conductors.
– Crimping force: ................................................................................................................230 kN
– Max operating pressure: .............................................................................................700 bar
– Oil necessary (displacement): ....................................................................................91 cm
– Dimensions: length .......................................................................................................290 mm (12.4 in.)
width .........................................................................................................120 mm (4.7 in.)
– Weight: ................................................................................................................................5,5 kg
2. INSTRUCTIONS FOR USE
2.1) Setting
The head is equipped with a "self-lock" quick male coupler suitable for connection to a hydraulic,
pneumatic or electrical pump from the Cembre range.
2.2) Die assembly
a) Dedicated dies
– Select the appropriate die set for the connector to be crimped.
– Extract the die retaining pin (09) from the head.
– Insert the lower die (26b) and align the groove (30) in the die, with the guide pins (15) in the head.
– Insert the upper die (26a) into the head.
– Insert the die retaining pin (09) in the head and through the upper die. Ensure the spring loaded
pin (10) is fully released.
b) Semi-circular dies
– Select the appropriate die set for the connector to be crimped.
– Extract the die retaining pin (09) from the head.
– Insert the lower half of adapter AU230-130D (31b) and align the groove (30) in the adapter, with
the guide pins (15) in the head.
– Insert the upper half of the adapter AU230-130D (31a) into the head.
– Insert the die retaining pin (09) into the head and through the adapter. Ensure the spring loaded
pin (10) is fully released.
3
HYDRAULIC PRESSHEAD
TYPE ECW-H3D
2
from 10 ÷ 630 mm
(Ref. to Fig. 1)
(4 AWG - 1250 MCM).
ENGLISH
(25.8 sh ton)
(10,000 psi)
3
(5.5 cu. in)
(12.1 lbs)