Makita XWT02 Manual De Instrucciones página 8

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Installing or removing socket
1
014643
Align the hole in the side of the socket with the detent pin
on the square drive and push the socket onto the square
drive until it locks into place. Tap it lightly if required.
To remove the socket, simply pull it off.
Hook
1
014638
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
OPERATION
CAUTION:
Always insert the battery cartridge all the way until
it locks in place. If you can see the red part on the
upper side of the button, it is not locked completely.
Insert it fully until the red part cannot be seen. If
not, it may accidentally fall out of the tool, causing
injury to you or someone around you.
014822
Hold the tool firmly and place the socket over the bolt or
nut. Turn the tool on and fasten for the proper fastening
time.
All manuals and user guides at all-guides.com
1. Socket
2. Square drive
2
1. Hook
2. Screw
3
3. Groove
2
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
Standard bolt
N m
(ft.lbs)
280
(207)
240
(177)
M20
200
(148)
160
(118)
120
M16
M16
(89)
80
M12
(59)
M12
40
(30)
1.0
1.5
0
0.5
Fastening time (S)
014827
High tensile bolt
N m
280
(207)
240
(177)
200
(148)
M14H
160
(118)
120
M12H
(30)
80
(59)
40
(89)
0
1.0
2.0
Fastening time (S)
014828
NOTE:
Hold the tool pointed straight at the bolt or nut.
Excessive fastening torque may damage the
bolt/nut or socket. Before starting your job, always
perform a test operation to determine the proper
fastening time for your bolt or nut.
If the tool is operated continuously until the battery
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery
cartridge.
The fastening torque is affected by a wide variety of
factors including the following. After fastening, always
check the torque with a torque wrench.
8
M20
2.0
M16H
M16H
M14H
M12H
3.0
Tabla de contenido
loading

Tabla de contenido