Glacier bay HD67824X-5001 Guía De Uso Y Mantenimiento página 5

Installation (continued)
3
Installing the standpipe to
mixer
NOTE: Do not reverse the hot and cold supply.
□
Thread the hot and cold supply onto the mixer
(K).
□
Install the standpipe (M) onto the mixer (K)
and tighten set screw (L) with the Hex wrench
(Hex: 2.0mm, F). Make sure that the screw
holes (1) are behind the standpipe (M).
Hot inlet
supply line
K
F
L
1
Cold inlet
supply line
L
1
M
4
Drilling the holes & Making the
waterline connections
□
Mark the locations for the screws with a pencil
(1). With an electric drill (2), drill three 1/4 in.
diameter holes for the screws in the oor.
Place the anchors (P) into the holes.
□
Connect the exible supply lines (3) to the water
supplies (4).
1
F
3
5
Please contact 1-855-HD-GLACIER for further assistance.
2
6mm dia.
P
4
P
3
4
HOMEDEPOT.COM
Floor
Floor