Installation - Glacier bay HD67824X-5001 Guía De Uso Y Mantenimiento

Installation

1
Preparing for installation
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old faucet.
Clean the surface in preparation for the new
faucet.
□
Loosen the set screw (J) pre-assembled to the
spout (A) with the Hex wrench (Hex: 2.5mm, E),
rotate the spout (A) about 90° to face the spout
(A) towards the front, then tighten the set screw
(J) with the Hex wrench (Hex: 2.5mm, E). Rotate
the bracket (1) about 90° to face the bracket (1)
towards the front.
A
1
2
□
A
J
E
4
Installing the escutcheon
Place the escutcheon (N) over the standpipe (M)
and then push it to the base.
N
M
N
M