Rowenta SO2035 Manual De Instrucciones página 10

Please read carefully and keep in a safe place.
1- WARNINGS
It is essential that you read these instructions carefully and comply with the following recommendations.
• For your safety, this appliance complies with the applicable standards and regulations (Low Voltage Directive, Electromagnetic Compatibility,
Environmental...).
• Before using, always check the condition of the appliance, the power socket and the power lead.
• Do not pull on the power cable or the appliance, even to unplug it from the wall socket.
• Fully unwind the lead each time before use.
• Never insert objects into the appliance (e.g. needles...).
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and know-
ledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
• Do not use your appliance in a dusty room or a room where there is a risk of fire.
• This appliance is intended for domestic use only. It must therefore not be used in industrial applications.
• The warranty will be void in the event of damage arising from improper use.
• If the power cable is damaged, it must be replaced by the manufacturer, its after-sales service or a person with similar qualifications to avoid any danger.
• Do not place the unit directly beneath an electrical outlet.
2 - VERY IMPORTANT
• WARNING: In order to avoid overheating, DO NOT COVER THE HEATER.
• Do not use the unit in the proximity of flammable objects or products
(curtains, aerosols, solvents, etc.)
• This appliance must not be used in damp places.
• Never use the unit in an inclined or horizontal position.
• Do not use this appliance near a bath, shower, sink or swimming pool.
• NEVER ALLOW WATER TO PENETRATE THE APPLIANCE.
• Do not touch the appliance with wet hands.
• In the event of a long absence: turn the button A to the initial setting
• However, the electrical installation in the room, the installation of the unit and the way the unit is used must all comply with the safety standards
in force in your country.
3 - VOLTAGE
• Before first use, make sure that the voltage being used corresponds to what is indicated on the unit and that the electrical installation is adapted to the
power level indicated.
• Your appliance can be used with a power plug without an earth connection.
It is a class II appliance (dual electrical insulation
4 - SAFETY
Heat safety
• In the event of abnormal overheating, a safety device shuts down the appliance and then automatically restarts it once it has cooled. If the fault persists or
gets worse, a thermal fuse shuts the appliance down definitively and it must then be taken to an approved service centre.
5 - OPERATION
Before turning the unit on, make sure:
- it is positioned as described in these instructions,
- that it is placed in a flat and horizontal position, and;
- that the air intake and outlet screens are free of all obstacles.
• Function Selection:
Select the desired function by turning switch (A) to line up the marking on the switch with one of the following symbols:
: Off
: Cooling
: "Silence" 1000W (SO2020) or 1200W (SO2035)
: 2000W (SO2020) or 2400W (SO2035)
• Indicator :
On/Off indicator C, lights up when the unit is turned on.
• Thermostat:
Adjust the temperature setting, according to your own comfort, by turning button B.
• Frost-free setting :
This setting enables you to automatically maintain the temperature above 0°C in a normally insulated room, whose volume corresponds to the power of your
appliance.
Plug in the unit and turn switch B to line up the marking on the switch with the "
Turn switch A to select one of the following :
• Cool fan setting :
This setting enables you to use your fan heater as a cooling fan in summer.
).
or .
7
and unplug the appliance.
" symbol.
EN