Tabla de contenido
Stopping the
Circulator
Power Down
Shut Down
Restarting
Thermo Scientific
• Press
to the left of the stop symbol,
stops and the stop symbol turns into a start symbol,
Menu
• Press
. The circulator's display goes blank and the blue LED
illuminates indicating it is in the stand by mode.
• On refrigerated baths, place the circuit protector on the rear
of the bath to the O position.
• Place the circuit protector on the rear of the immersion
circulator to the O position. The blue LED extinguishes.
Using any other means to shut the circulator down can reduce the
life of the compressor.
Always turn the circulator off and disconnect it from its supply volt-
age before moving.
The circuit protector(s) located on the rear of the component(s) is
not intended to act as a disconnecting means.
Note When quickly restarting refrigerated baths, the compressor may take
up to 10 minutes before it starts to operate.
20.00°C
Section 4 Operation
. The circulator
.
SP1
20.00C
I
O
4-27
Tabla de contenido
