Tabla de contenido
Ambient
Conditions
Immersion Circulator
DANGER
CAUTION
CAUTION
Thermo Scientific
Section 3
Ambient Temperature Range
Maximum Relative Humidity
Operating Altitude
Overvoltage Category
Pollution Degree
Degree of Protection
*decreasing linearly to 50% relative humidity at 40°C (104°F)
Ensure the label and small piece of Styrofoam securing the float switch are
removed before using.
Only
The circulator is designed for continuous operation and for indoor use.
For stand-alone immersion circulators use the supplied nut and
washer to secure the grounding strap to the top of the metal tank. See
next page.
Never place the immersion circulator in a location where excessive
heat, moisture, inadequate ventilation, or corrosive materials are
present.
Carefully install the immersion circulator to ensure it does not fall
into the container or that its line cord does not make contact with the
container contents.
For immersion circulators equipped with a bridge:
•
The bridge is designed to fit containers that are 400 mm to 800 mm wide.
•
Slide the bridge support rods to the desired length and secure them in
place with the supplied eight 3 mm Phillips Head screws.
•
If possible, secure the bridge to your container using the two supplied
thumbscrews.
•
The immersion depth is 75 to 145 mm (~3 to 5
Your container must be sturdy enough to support the weight of the assembly,
approximately 3.8 kilograms (8.5 pounds). The circulator is designed for
continuous operation and for indoor use only.
Installation
80% for temperatures up to 31°C (88°F)*
Sea Level to 2000 meters (6560 feet)
5°C to 40°C (41°F to 104°F)
II
2
IP 20
/
").
3
4
3-1
Tabla de contenido
