Tabla de contenido
Section 3 Installation
Bath Circulator
CAUTION
CAUTION
CAUTION
Grounding Strap
and Nut
DANGER
3-2
The circulators is designed for continuous operation and for indoor use.
The equipment normally ships with the immersion circulator mounted facing
the reservoir. You may change the position ±90° by removing thumb screws,
no tools are required.
Do not mount it backwards; the line cord could contact the reservoir
fluid.
Rotate immersion
circulator only ±90°
from shown position
Never place the circulator in a location where excessive heat, moisture,
inadequate ventilation, or corrosive materials are present.
Leave refrigerated baths in an upright position at room temperature
(~25°C) for 24 hours before starting. This will ensure the lubrication oil
has drained back into the compressor.
Sahara baths, and stand-alone circulators, require immersion circulator
grounding.
For Sahara baths, and stand-alone immersion circulators, use the
supplied nut and washer to secure the grounding strap to the top of
the metal tank.
Thermo Scientific
Tabla de contenido
