Technical Data - YATO YT-09540 Manual De Instrucciones

CHARACTERISTICS OF THE TOOL
Pneumatic wrench is a tool that is powered with a stream of compressed air at appropriate pressure. Wrench-
es installed on a collector make screwing down and unscrewing possible, particularly where a high turning mo-
ment is required. Correct, reliable and safe functioning of the tool depends on correct operation, therefore:
Before operation of the tool can be commenced, the whole manual must be read and kept.
The supplier cannot be held responsible for any damages or injuries which are caused by using the tool in
a manner that does not correspond to its purpose, not observing safety regulations or the recommendations
of the present instructions. Using the tool in a manner that does not correspond to its purpose also cancels
the guarantee.
EQUIPMENT
The pneumatic wrench is equipped with a connector that facilitates its connection to the pneumatic system.

TECHNICAL DATA

Parameter
Catalogue number
Length
Weight
Diameter of the air connection (PT)
Inside diameter of the air supply
hose
Rotations
Maximum turning moment
Size of the collector
Maximum working pressure
Required air flow (at 0.63 MPa)
Acoustic pressure (EN ISO 15744)
Acoustic power (EN ISO 15744)
Vibrations (EN ISO 28927-2)
GENERAL SAFETY CONDITIONS
WARNING! During operation of a pneumatic tool, it is recommended to always observe the basic safety regu-
lations including those mentioned below, in order to diminish the risk of fire, electric shock and injury.
Before operation of the tool can be commenced, the whole manual must be read and kept.
ATTENTION! Read all the instructions mentioned below. If they are not observed, there is a risk of electric
shock, fire or injury. The notion of „pneumatic tool" that is used in the instructions refers to all tools that are
powered with a stream of compressed air at appropriate pressure.
OBSERVE THE FOLLOWING INSTRUCTIONS
12
O R I G I N A L
GB
Measurement
unit
YT-0953
[mm] 193
[kg] 2,02
[" / mm] 1/4 / 6,3
[" / mm] 3/8 / 10
[min ] 10 000 ±10%
-1
[Nm] 1356
[" / mm] 1/2 / 12,5
[MPa] 0,63
[l/min] 153
[dB(A)] 93,7 ± 3,1
[dB(A)] 104,7 ± 3,1
[m/s ] 4,4 ± 0,4
2
I N S T R U C T I O N S
Value
YT-09505 YT-09540
170 195
1,40 2,05
1/4 / 6,3 1/4 / 6,3
3/8 / 10 3/8 / 10
10 000 ±10% 10 000 ±10%
570 1150
1/2 /12,5 1/2 / 12,5
0,63 0,63
142 153
90,7 ± 3,0 93,7 ± 3,1
101,7 ± 3,0 104,7 ± 3,1
3,0 ± 1,5 4,4 ± 0,4
YT-09571
221
3,81
3/8 / 10
1/2 / 12,5
5500±10%
1630
3/4 / 19
0,63
198
100,6 ± 3,0
111,6 ± 3,0
10,21 ± 1,5