Step 3. Water Fill - Kenmore 758.15412010 Manual De Uso

Step 3. Water Fill
WARNING: To reduce the risk of fire
or shock hazard, do not pour or spill
water into control or motor area. If
controls get wet, let them dry
completely and have unit checked by
authorized service personnel before
plugging in.
After the humidifier is positioned where
it will be operating you are ready to
fill the humidifier. The bottle lifts
straight up and away from the base.
Take care not to bump or damage fill
valve assembly on the bottom of the
bottle.
Remove the "E-Z Fill Side Cap" and fill
with water. Replace cap and twist by
hand until secure. Hold the bottle
upright over the sink. Press up on the
valve plunger for one second to release
a small amount of water. If you hear
air bubbles or see leaks around the "E-
Z Fill Side Cap" or Spring Valve
Assembly, retighten and recheck.
CAUTION: Use only 32-14900 EPA
Registered Bacteriostat available
from Sears Retail store. Under no
circumstances should you use water
treatment products designed for Roto
belt or Ultrasonic humidifiers.
Bottle \
Turn Counterclockwise to
Remove "E=Z Fill Side Cap"
/
Spring Valve
Assembly
Place the water bottle back into the
humidifier base. When positioned
properly, the plunger will open and
the water will flow into the base. The
base will hold the entire contents of
the water bottle. Once the bottle is
empty, remove it and repeat the
filling process. The humidifier is now
filled to capacity. To benefit from less
frequent filling, let the humidifier
exhaust both the water from the
bottle and the base before filling.