Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Replacement
and Care of Filter
WARNING:
To reduce
the
risk of shock or injury from
moving
parts,
always unplug
humidifier
before
removing
or replacing
any parts.
6.
Return the housing
assembly
to the
top of the base. Reposition
the
humidifier
to its operating
position.
7.
The humidifier
is now ready
to be
filled
for operation.
CAUTION:
To help retard
bacteria
growth
and keep maximum
efficiency,
the filter
should
be
replaced
at least once per season,
or more often
under
hard water
conditions.
Use Kenmore
32-14906
recommended
replacement
filter.
Replace
the evaporative
wicking
filter
at least once per humidification
season or more depending
on water
conditions
in your area.
Filter Replacement
1.
Unplug
humidifier.
Before
removing
the filter,
we recommend
moving
the
humidifier
to an area where
floor
coverings
are not susceptible
to water
damage.
(i.e. kitchen
or bath
areas.)
2.
Remove
the water
bottle
and set
aside. Be sure not to bump
or
damage
the fill valve.
3.
Grasp
the housing
assembly
and lift
straight
up and away
from the base
and set aside. The filter
is now
accessible.
4.
Take note of the filter
position.
Remove
the filter.
You may want to
clean the base at this time. See the
"Cleaning
Your Humidifier"
section
of
this manual.
5.
Install a new filter
(32-14906)
into the
base. Coil the filter
and position
it
between
the uprights
in the bottom
of
the base. The start and finish of the
coil should
be captured
at the center
of the base (see diagram)
and the
filter
should
be resting on the floor
of
the base.
Grasp housing
assembly
securely and
lift off ..............
\\\_
Position start
.
and finish of
coiled filter at
of base
/ top of base
/
and reposition
securely
Tabla de contenido
