Hozelock 4705 Manual De Instrucciones página 4

Maintenance • Entretien • Wartung • Onderhoud • Mantenimiento • Underhåll • Vedlikehold • Huolto • Vedligehold
Manutenzione • Manutenção • Konserwacja • Συντήρηση • Bakım • Karbantartás • Zdr ba • Техническое обслуживание
Hooldamine • Tehniskā apkope • Priežiūra • Întreţinere • Обслуговування • Vzdrževanje
21 22
I
B
C
D
GB
Thank you for choosing a Hozelock quality sprayer, you can be
assured of many years of reliable service from this product.
Instructions & Warnings
• This sprayer is intended for use with water-based solutions
of: insecticides, fungicides, weedkillers and fertilizers.
• Always follow the chemical suppliers instructions, as well as
the instructions supplied with this sprayer.
• Make sure all connections are hand tight before use.
• If the sprayer has been used with chemicals, discard safely
any unused solution after use.
• Always use eye protection when replacing valves, seals or
springs
• Before carrying out any maintenance on this sprayer
it is essential to depressurise the bottle, by lifting the
pressure release knob.
Always wear protective clothing, goggles, face mask and
gloves.
Avoid inhaling spray mist.
Avoid skin contact with chemicals.
Always work in a well ventilated area.
Take care to protect children, pets & fish from exposure to
chemicals.
Always wash hands thoroughly after use & especially
before eating.
Always wash any contaminated clothing.
Seek medical attention if spray gets in your eyes or you
develop any symptoms after spraying.
Do not spray near food or food preparation areas. When
spraying crops, pay particular attention to the chemical
manufacturers advice on time before crops can be eaten.
Do not spray any solvent e.g. White spirit.
Spray only thin watery solutions; thicker mixtures will clog
the nozzle.
J
A
A
A
23
B
25
Powdered chemicals can be sprayed successfully if they
are completely soluble in water. If they are not, or the
solution tends to settle, spraying can still be successful if
the mixture is continually agitated.
If the material to be sprayed contains sediment, strain the
liquid into the sprayer bottle.
Do not over pressurize the bottle. The pressure release
valve is designed to release excess pressure, and must not
be tampered with, or forced to remain closed.
Winter use – drain liquid from all parts and loosen pump
assembly.
Annual maintenance – At least once per year thoroughly
clean the whole sprayer and apply silicone grease to all
moving parts & seals. Test with water, and if any washer or
seal has perished it must be replaced.
Ensure the hose fully covers the barbed details on both
A
the lance and the outlet connector. Make sure all nuts are
hand tight before use.
This sprayer is made from many types of plastic, and
B
although the liquid you wish to spray may also be packed
in plastic, this does not guarantee it will not damage
the sprayer. If you have any doubt about compatibility,
contact Hozelock consumer services. When filling the sprayer, or using the dosing cup, always use the large
filling aperture, and ensure that the maximum fill level is
not exceeded.
C
Ensure that the pump and dosing cup is screwed into the
bottle tightly before pressurising and locked in position.
Before operating the pump, operate the pressure
D
release valve manually by lifting the knob to ensure
it is free to move, then release the handle by rotating
anticlockwise, pressurise bottle and then lock back in
position.
After using the sprayer, manually operate the pressure
E
release valve as above, to depressurize.
24
K
26
M
Notes
L
N