Utilitech 7131-02 Manual De Instrucciones página 9

EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
3. Remove wiring box cover (3.1) from fan housing (A).
Remove wiring knockout (3.2) from wiring box cover
with flathead screwdriver (not included).
4. Pull the house wires through the wire box cover hole.
Using a quick connector, secure 120 V AC house wiring
from the wall switch to the fan as shown in the wiring
diagram on page 5. 14 AWG is the smallest conductor
that should be used for branch-circuit wiring.
Carefully push the connected wires back into the
wiring box housing. Reattach the wiring box cover.
CAUTION: If the electrical wires do not match the
colors listed, you must determine what each house
wire represents before connecting. You may need to
consult an electrical contractor to determine safely.
5. Install a circular 3 in. duct (not included) and secure it
with duct tape or clamps (neither included) to the fan
housing (A).
3
A
2.2
3.1
2.1
4
5
3 in. duct
9
2.3 3.2
Quick
connector
House
wires
Product
wires
A
Ceiling
Duct tape
or clamp