Idiomas disponibles
Idiomas disponibles
GB
OPERATION
I DRIVE
1
3
2
ANTI-ODOUR FILTER ACTIVATION WARNING:
If the hood is installed in filter mode, the anti-odour filter saturation warning must be activated, indicating when the fil-
ter needs to be replaced. With the hood off, press and hold the knob for a few seconds – the function will be enabled or
disabled: 4 green flashes for the symbol (F) indicate the function is enabled, whereas 4 red flashes indicate it is disabled.
Press the Push key to activate the hood; the four 4 icons will light up in blue. Press these icons lightly to enable them and
enter a specific function. The hood will memorize the latest selected settings, i.e. aspiration power and lights.
Press this control button to start up the motor, (at the same aspiration power selected before it was last switched off ); the
green pilot light will light up. Turn the knob clockwise or counter-clockwise to increase or decrease the aspiration power: the
light indicators in this section (1) show the aspiration power, which varies from 0 to 6. After 5 seconds, if no action is taken on
the knob, the system will exit the motor function and the green pilot light will turn blue once again, disabling the possibility
of changing settings. Press the control button a second time while it is still green to power off the motor and exit the function.
Automatic heat sensor functioning:To select this function, press the motor button and turn the handle in an anticlockwise
direction until the light on the motor button begins to flash. The temperature sensor will start the motor, selecting the right
aspiration speed. The speeds will vary in accordance with the change in temperature from the cooking top.
Press this control button to switch the lights on over the stove (at maximum intensity); the pilot light will light up to green.
After 5 seconds, if no action is taken on the knob, the system will exit the light function and the green pilot light will turn blue
once again, disabling the possibility of changing settings. Press the control button a second time while it is still green to power
off the lights and exit the function.
Press this control button to enable the hood's timer function; the pilot light will light up to green. Turn the knob clockwise or
counter-clockwise to increase or decrease the automatic shutdown timer: the light indicators in this section (3) show the
set time, from 5-10-20-40 minutes. After 5 seconds, if no action is taken on the knob, the system will exit the timer function
and the green pilot light will turn blue once again, disabling the possibility of changing settings. Press the control button a
second time while it is still green to reset the timer to zero and exit the function.
The hood features two warnings, one for the saturation of the anti-odour filter (if the function has been activated) and the
other for the metal filter. The red pilot light will light up when the control button is pressed once, showing the metal filter's
saturation condition. When the control button is pressed a second time the pilot light will turn purple, showing the satura-
tion condition of the anti-odour filter, if previously activated; in this case, the light indicators in this section (1) show the
degree of saturation of the filters. When the timer for the metal filter reaches 40 hours, the pilot light will flash red to indicate
that the metal filter must be cleaned, whereas it will flash purple after 120 hours to indicate that the anti-odour filter needs to
be replaced. To reset the warning, enter the filter status menu, select the filter in alarm mode, then press and hold the knob
until the pilot light is switched off.
All hoods with capacities exceeding 650 m3/h have the last timed speed; It lasts for 7 minutes, after which it automatically
returns to the last non-timed speed.
26
