SEA CORONA 60 Manual Del Usuario página 3

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
385
Before installing, control that the door is perfectly working and that it does not have any obstacle on the guides.
1. ISTALLATION
- Connect the aluminium sections by using the two connecting sections.
- Put the connecting section into the aluminium section until the middle of its length (150 mm) and fix it with the A screw. (Fig. 4)
- Make the same with the other two aluminium sections
- Put the two supplied screws (B) into the holes of the aluminium sections (Fig. 4)
B
B
Notice: In Fig.4 there is a couple of screws put inside the holes which will be used to fix Corona to the ceiling through the provided sections (See
also Fig. 7).
- Put the two extremities of the chain together using the link and two provided screws as in Fig.5.
- Make sure the chain has been correctly put in the pinion of the Corona body (Fig. 7 - A)
- Bring the guide to the stop on the Corona body and fix it with the provided bracket (Fig. 7 - B)
- Fix the front connection support to the other extremity of the guide. (Fig. 7 - C)
- Tighten the chain lightly acting with a 10-key as in Fig.6
Notice: The chain and the sliding support must be always lubricated. (Fig. 7 - D).
Fig. 5
67410620
®
Aluminium
Section
B
A
CORONA
2500 Max Running
3310
Aluminium
Section
Connecting
Section
Rev 09 - 03/2011
150
Connecting
Section
A
ENGLISH
Fig. 3
200
Fig. 4
Aluminium
Section
Fig. 6
13