SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install
the product.
WARNING
For indoor/outdoor use.
Place the fountain in a location where any water spills or splashing will not reach any other
electrical equipment or cause damage. Choose an appropriate location before installing the
fountain. DO NOT lift or push/drag the water basin to relocate the fountain when it's filled with
water. Empty the water basin before lifting. Excessive weight or pressure on any of the fountain
sections may cause it to tip or fall over. Keep pets and children away from any of the fountain
sections. Some splashing may occur. The pump on the fountain has no user-serviceable parts.
Only an authorized service representative should service the pump. Do not open the sealed
pump housing as this may result in electrical shock. Refer to enclosed pump maintenance
guide for cleaning.
To avoid injury from electrical shock, observe basic safety precautions and comply with the
following instructions:
1. Install the fountain pump correctly before operating it.
2. DO NOT allow the pump to run dry.
3. An adult should supervise children when they are around the pump.
4. Use the proper power source as indicated on the pump label.
5. Equip the electrical power for the pump with a ground fault circuit interrupter (GFCI) wall output.
6. If any of the fountain's attached sections with electrical lights or components fall into the water
located in fountain base, unplug the fountain and turn off circuit breaker before trying to put the
fountain pieces back in place.
7. If any leakage occurs around the pump housing, turn off the circuit breaker immediately and
have the pump serviced by a registered technician.
8. Do not operate the fountain if the pump has been dropped or has a damaged power
cord or plug.
9. If the plug or the wall receptacle gets wet due to water dripping down the power cord or for any
other reason, do not remove the plug from the wall outlet until the circuit breaker is turned off.
NOTE: Allow the pump power cord to hang at a lower level
than the wall outlet to form a "drip loop". This will help
prevent water from dripping down the power cord and
getting into the wall outlet.
10. Always unplug the fountain pump and any other independent electrical accessories (e.g lights)
from the outlet when not in use and before cleaning or replacing parts.
11. Disconnect the power cord from the outlet by holding the plug, not by pulling on the power cord.
12. Periodically change the water. Clean the fountain water basin, the pump's outlet nozzle and
the water tube for dirt and debris with a damp cloth if necessary.
13. Do not expose the pump to direct sunlight or to low temperatures for any period of time.
14. Keep the power cord away from high temperatures or heat sources.
15. Use only a UL-approved extension cord of the correct rating to avoid overheating.
16. Only use fountain parts provided by the manufacturer.
17. Do not use the pump for anything other than its intended use.
18. This fountain pump is not intended for commercial use.
Lowes.com/gardentreasures
3
GFCI
DRIP LOOP