Brake Adjustment; How To Order - Bulldog DC Serie Manual De Instrucciones

3.3 Brake Adjustment

Under normal use, the brake mechanism will not require any adjustment. If the brake fails to hold a
load, the brake disc may be worn and require replacement. When the brake wears to the point that the
load begins to slip, the brake can be adjusted as follows:
1. Loosen the bolt on the brake cover and take out the retaining rings
2. Insert spacers/washers to maintain the brake spacer between to be 2.2 ± 0.25 mm
3. Make sure to keep the clutch base plate is rotated counter-clockwise by 150 – 180 degree
3.4 Lubrication
All moving parts in the winch are permanently lubricated at the time of assembly. Under normal con-
ditions factory lubrication will suffice. If re-lubrication of gear box is necessary after repair or disas-
sembly use Shell EP2 or equivalent grease. Regularly lubricate Clutch T-handle with light oil. Never
lubricate the brake system.
3.5 Tie Rod Replacement
1. Disconnect power to your winch.
2. Loosen and remove the tie rod bolts and remove the
tie rods.
3. Replace the tie rods and tie rod bolts.
4. Using an adjustable wrench to hold the flat spots on
the tie rod; torque the tie rod bolts according to the
Table 7.
5. Reconnect power to your winch.
3.6 How To Order Replacement Parts
Use only Cequent Performance Products' parts or parts of equal quality for repair. Replacement
parts are available through Cequent Performance Products' Tech Service Department,
1-800-632-3290. Please specify product model number.
24
CEQUENT
Maintenance
Figure 41 - Brake Adjustment
PERFORMANCE PRODUCTS, INC. •
™
Table 7 - Tie Rod Mounting
Torque Requirements
Powered DC6000,
Winches DC9000,
DC12000L
Tie Rod M8 x
Bolt Size & 1.5 pitch
Torque 8.8 grade
20 ft./lbs.
F3838-00 REV C (4782) 7/15
DC12000,
DC15000,
DC18000
M10 x
1.5 pitch
8.8 grade
40 ft./lbs.