Filling The Magazine; Eu Declaration Of Conformity - KMR 3725 Manual Del Usuario

Device-specific additional instructions for nailer
4

Filling the magazine

Ensure that nailer and fasteners are compatible (Chap. 1) with
•
each other.
Check fasteners for proper condition.
•
Put nailer carefully down in defined safe resting position
•
(Chap. 3): The driving nose must point away from any
person. It must be impossible to unintendly actuate trigger
and/or release protection.
Insert nail strip into the magazine from the rear and push
•
forward. Pull pusher 1 backwards behind the nail and push it
forward again.
5 Hole finding in the wood connector
Position the tip of the tool in the hole of the wood
•
connector. Press down and trigger the tool.
6

EU Declaration of conformity

Friedrich
The Joh. Behrens AG, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's
conformity with all relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
-------------------------------------------------
Tobias Fischer-Zernin, Management
...3725
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7