Televes 5096 Manual De Instrucciones página 29

User manual
• LED indicators:
A B C
To modify this value, it is necessary to press
the
button, this will make the first digit
blink ON and OFF.
Then press or to change its value
between 0 to 9.
If the button is pressed again, the next
digit is selected and will start to blink. This
can also be modified in the same way.
Repeat this process until the three digits are
displaying the desired address.
All of the devices that can be remote
controlled by the Televés headend control
system are interconnected to a Common
Control Bus (front panel connector labelled
"Ctrl") and each device should have a
unique address within the bus (between 1
and 254).
It is the installer's responsibility to ensure
that all the addresses are unique and that
none have been repeated on this bus.
5.2.2. - Freq./Channel operational mode
Press to access the menu that offers the
Frequency or Channel operational mode
options.
Press and to select one of the two
available operational modes.
The display will show:
• Frequency mode
• Channel mode
By pressing or the following permitted
values will appear in this mode: Ct.7, Ct.6,
Ct.5, Ct.4, Ct.3, Ct.2, Ct.1 (See these 7
channel tables on page 32).
29
Analogue Channel Processor
5.2.3. - Amplifier/Converter selection
Press again to access this menu.
The display will show one of the two options
that can be selected by pressing any one of
the and buttons:
• Unit as a Converter:
• Unit as an Amplifier:
Input channel = ontput channel