Help And Support - HP ENVY Pro 6400 Referencia Y Soporte

Help and tips for Wi-Fi and connectivity
If the software is unable to find your printer during setup, check the following conditions to resolve
the issue.
Potential Issue
Printer Wi-Fi setup mode timed out
Computer or mobile device too far from
printer
Computer connected to a Virtual Private
Network (VPN) or remote work network
Wi-Fi turned off on computer (computer
connected by Ethernet)
Bluetooth and location services are
turned off on your mobile device
The information contained herein is subject to change without notice.
If the status light is not purple, the printer might not
be in Wi-Fi setup mode. Restart setup mode:
Move your computer or mobile device closer to the
printer. Your device might be out of range of the
printer's Wi-Fi signal.
Disconnect from a VPN before installing HP Smart
software. You can't install apps from the Microsoft
Store when connected to a VPN.
Connect to the VPN again after finishing printer setup.
If your computer is connected by Ethernet, turn on
the computer's Wi-Fi while setting up the printer.
Disconnect the Ethernet cable temporarily to
complete setup over Wi-Fi.
If setting up with a mobile device, turn on Bluetooth
and location services. This helps the software find
your network and printer.

Help and Support

For printer information, troubleshooting, and
videos, visit the printer support website.
Solution
1. On the back of the printer, press and hold the Wi-Fi
Reset button for 5 seconds and then release
the button. The status light will pulse purple.
2. Wait for one minute. Close and reopen HP
Smart, and then try connecting again.
Note: Consider your location and the security of the
Wi-Fi network before disconnecting from a VPN.
Note: Your location is not being determined and
no location information is being sent to HP as
part of the setup process.
hp.com/support