Water Container; To Remove The Container; Operation - Candy GCH 970NA1T Manual De Instrucciones

The water removed from the laundry during
the drying cycle is collected in a container
inside the door of the dryer. When the
container is full the
panel will light, and the container MUST be
emptied. However, we recommend that the
container is emptied after each drying cycle.
NOTE: Very little water will collect during the
first few cycles of a new machine as an internal
reservoir is filled first.

To Remove the Container

1. Gently pull out the
t r a y u n t i l i t
completely removed.
Support the tray with
both hands. When it is
full the water container
will weigh about 4kg.
2 . Ti l t t h e w a t e r
container to empty the
water out through the
rear hole.
When emptyslide the
water container back
into position.
PUSH FIRMLY INTO
PLACE.
3. Press to restart
the cycle.
NOTE: If you have the
option of drainage near
the dryer it is possible
to use the discharge kit
to provide a permanent
drain for the water
collected by the dryer.
This will remove the
need to empty the
water tray. All the
i n f o r m a t i o n f o r
assembly of the kit is
contained in the kit
envelope.
indicator on the control
i s

WATER CONTAINER

OPERATION

1. Open the door and load the drum with
laundry. Ensure that garments do not hinder
closure of the door.
2. Gently close the door pushing it slowly until
you hear the door 'click' shut.
3. Turn the Programme Selector dial to select
the required drying programme (see
Programme Guide).
4. If drying synthetics, acrylics or delicate items,
press the button to reduce the heat level.
The indicator will light up when the machine is in
low heat setting. To deselect in the first few
minutes of the programme, press the
, after this time reset the machine to change the
setting.
5. Press the button. The dryer will start
automatically and the indicator above the
button will be continuously lit.
6. If the door is opened during the programme to
check the laundry, it is necessary to press
recommence drying after the door has been
closed.
7. When the cycle is nearing completion the
machine will enter the cool down phase, the
clothes will be tumbled in cool air allowing the
load to cool down.
8. Following the completion of the cycle the
drum will rotate intermittently to minimize
creasing. This will continue until the machine is
switched OFF or the door is opened.
Do not open the door during the automatic
programs in order to obtain a proper drying.
button
to
EN 11