Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
Cool Mode
Use the Cool mode with HIGH (F3), MED (F2) or
LOW (F1) fan for cooling. Use the INCREASE L /
DECREASE M pads to set the desired temperature
between 60°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the
room temperature. The compressor will cycle on and
off to keep the room at the set level of comfort. Set
the thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to a Cool setting or if turned from a fan setting
to a Cool setting, it will take approximately 3 minutes for
the compressor to start and cooling to begin.
Fan Speed Mode
Use the fan at HIGH (F3), MED (F2) or LOW (F1) to
provide air circulation and filtering without cooling.
Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
Vent Control
The vent control is located beside the control
panel.
When set at CLOSE, only the air inside the room
will be circulated and conditioned. When set at
OPEN, some inside air is exhausted outside.
Air Direction—Side-to-Side
The side-to-side air direction is adjusted by moving
the lever to the left or right.
Air Direction—Up and Down
Fingertip pressure on the horizontal louvers
adjusts the air direction up or down.
Cooling Descriptions
For Normal Cooling—Select the Cool mode and
HIGH (F3) or MED (F2) fan with a middle set
temperature.
For Maximum Cooling—Select the Cool mode
and HIGH (F3) fan with a lower set temperature.
For Quieter & Nighttime Cooling—Select the
Cool mode and LOW (F1) fan with a middle set
temperature.
NOTE: If you switch from a Cool setting to OFF or to
a fan setting, wait at least 3 minutes before switching
back to a Cool setting.
To open the vent, pull the lever toward you.
To close it, push it in.
ge.com
5