NEC NP04WK Manual De Instalación Y Ajuste página 11

2. Attach the wall adapter to the wall's structural material.
Use the included washers and spacers to attach the wall adapter with the M6 screws (or bolts).
- For the position for mounting the wall adapter onto the wall and the dimensions, see "Dimensions
of Parts" on page ENG-6 and "Projection Distance and Screen Size" on page ENG-7.
- Be sure to fasten the screws at the center of the mount holes, as they will serve as the refer-
ence points for the horizontal position.
- The wall adapter must be
installed in the proper up/
down direction. Mount it
in the direction shown on
the diagram.
- The horizontal position
adjustment range is ±50
mm.
CAUTION
- Mounting should be per-
formed by two people.
WARNING
- Be sure to use M6 (1/4 inch) screws or bolts (4 locations)
to fasten the bottom of the wall adapter. Using anything
other than M6 screws (or bolts) could result in the projec-
tor falling and causing injury.
3. Attach the projector to the mount plate.
Line up the screw holes in the mount plate with the screw holes on the bottom of the projector and
securely tighten the four included M4×8 screws.
- Place a thick, soft cloth, etc., on the floor to protect the projector from scratches.
Note: "MAX.M4 x 8" is indicated on the four screw holes on the bottom of the projector. Note that
this indication is not for this product's projector adapter.
CAUTION
- Be careful not to touch the projector's pro-
jection window when mounting the projector.
WARNING
- Mounting the projector using screws
other than the included ones could
damage the projector or result in it
falling and causing injury. Be sure to
use the included screws.
2 m
1 4
m
9 m
1 8
Wall adapter
Mount plate
ENG-10
Mount holes
m
Spacer
Washer
M4×8 screws