Connection Diagram - Alesis DM10 Manual De Inicio Rápido

CONNECTION DIAGRAM

WARNING:
Use only the
included Alesis
power supply
with the DM10
module.
POWER
COMPUTER
•
Connect your electronic drum set's triggers to the corresponding inputs on the module with the
appropriate 1/4" cables. Dual-zone pads or cymbals (e.g., a drum with head and rim triggers or a
cymbal that can produce bow and bell sounds) will require TRS cables to trigger both zones.
•
Plug 1/4" TRS cables from the MAIN OUT or AUX OUT to an amplifier, mixer, or speaker system. (For
mono sound, you can connect only one output.)
•
You can connect a set of 1/4" TRS headphones to the HEADPHONES OUTPUT.
•
You can connect another audio device to the AUX IN using standard RCA cables.
See the included assembly poster for further instructions on setting up the DM10 Kit and connecting it to
the DM10 module.
NOTE: Out of the box, the DM10 module is write-protected, so you will be unable to save any changes
you make to the Kits, Instruments, Sequences, etc. To turn write protection off:
1. Press UTILITY.
2. Press SYS (F4).
3. Press O/S (F3).
4. Press MEM (F4).
5. Press VALUE DOWN or move the VALUE DIAL counterclockwise until the "WriteProt" field
says "OFF."
6. Press DRUM KIT to return to the main page.
IMPORTANT: THE DM10 MODULE MAY BE AFFECTED BY STATIC ELECTRICITY.
OCCURS, SIMPLY TURN THE MODULE OFF AND WAIT AT LEAST A FEW SECONDS BEFORE
TURNING IT ON AGAIN.
DRUM KIT EXTERNAL MIDI MODULE
CD PLAYER
1
MIDI KEYBOARD
- octave +
m1
tap
m2 accomp store
volume pitch x y z
phrase latch
HOUSE AMP
MONITORS
push
a n a l o g m o d e l i n g s y n t h
IF THIS