Torque Limiter - Makita DHR263 Manual De Instrucciones

Selecting the action mode
Rotation with hammering
1
014397
For drilling in concrete, masonry, etc., depress the lock
button and rotate the action mode changing knob to the
symbol. Use a tungsten-carbide tipped bit.
Rotation only
1
014398
For drilling in wood, metal or plastic materials, depress
the lock button and rotate the action mode changing
knob to the symbol. Use a twist drill bit or wood bit.
Hammering only
1
014399
For chipping, scaling or demolition operations, depress the
lock button and rotate the action mode changing knob to the
symbol. Use a bull point, cold chisel, scaling chisel, etc.
CAUTION:
Do not rotate the action mode changing knob
•
when the tool is running. The tool will be damaged.
To avoid rapid wear on the mode change
•
mechanism, be sure that the action mode
changing knob is always positively located in one
of the three action mode positions.

Torque limiter

The torque limiter will actuate when a certain torque
level is reached. The motor will disengage from the
1. Rotation with
hammering
1. Rotation only
1. Hammering only
7
output shaft. When this happens, the bit will stop turning.
CAUTION:
As soon as the torque limiter actuates, switch off
•
the tool immediately. This will help prevent
premature wear of the tool.
Hole saws cannot be used with this tool. They
•
tend to pinch or catch easily in the hole. This will
cause the torque limiter to actuate too frequently.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Side grip (auxiliary handle)
1
2
3
4
5
014403
CAUTION:
Always use the side grip to ensure operating
•
safety.
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
Bit grease
Coat the bit shank head beforehand with a small
amount of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.).
This chuck lubrication assures smooth action and longer
service life.
Installing or removing the bit
Clean the bit shank and apply bit grease before
installing the bit.
1
009664
1. Grip base
6
2. Teeth
3. Loosen
4. Tighten
5. Side grip
6. Protrusion
1. Bit shank
2. Bit grease
2